Channel-3™ FAQs
Q1: Can Channel-3 be used to just delay a single channel?
A1: Yes. Channel-3 can delay a channel, delay it and slow it, delay it, slow it and reverse it or delay, slow, reverse and modify endpoints in any combination.
Q2: The new Channel-3 actually has two channels now, but are these channels completely independent?
A2: The second channel must obviously be a function of one or both of the input channels that are connected to the Channel-3 board. In that sense, they are not independent. The thresholds, end point settings, and high or low qualifiers are all completely independent.
Q3: Can the speed of the new oscillating feature be adjusted?
A3: Yes, it is fully adjustable.
Q4: Can I use Y-Connectors with Channel-3 so that I have 2 copies of each input?
A4: Yes. Channel-3 places a very small load on the receiver outputs, and our testing has shown that the input signals can be split using a Y-Connector with no significant loss in signal quality.